DBPapers
DOI: 10.5593/sgem2017/32/S13.004

ASSESSMENT OF PLASTIC LIMIT OF SOIL BASED ON FALL CONE TEST

E. Hrubesova, B. Lunackova
Monday 11 September 2017 by Libadmin2017

References: 17th International Multidisciplinary Scientific GeoConference SGEM 2017, www.sgem.org, SGEM2017 Conference Proceedings, ISBN 978-619-7408-05-8 / ISSN 1314-2704, 29 June - 5 July, 2017, Vol. 17, Issue 32, 27-32 pp, DOI: 10.5593/sgem2017/32/S13.004

ABSTRACT

The paper presents the results of standard plastic limit test and fall cone test also used to determine plastic limit. Tests were performed on three clay soils. Soils differed from each other various percentage of the sand fraction.
Plastic limit is standardly determined by hand rolling soil specimen. A sample of soil has moisture on plastic limit when the roller of the soil of 3 mm diameter begins to break up (CSN EN ISO/TS 17892-12). The test results are highly dependent on access laboratory technicians which proves the high value of the variance and standard deviations when evaluating the results of tests carried out on mentioned samples of soils. A new method, which can eliminate subjective approach of this test, is performed to determine the plastic limit using fall cone test. This presented alternative method is based on Hansbo theory (1957). This theory shows that the undrained shear strength of soil is inversely proportional to the square of the cone penetration. Comparison of plastic limit, obtained on the basis of standard scrolling test and cone penetration test, was presented in this paper.

Keywords: plastic limit, fall cone test, clay-sand mixture

Home | Contact | Site Map | Site statistics | Visitors : 0 / 353063

Follow site activity en  Follow site activity SOILS  Follow site activity Papers SGEM2017   ?

CrossRef Member    Indexed in ISI Web Of Knowledge   Indexed in ISI Web Of Knowledge
   

© Copyright 2001 International Multidisciplinary Scientific GeoConference & EXPO SGEM. All Rights Reserved.

Creative Commons License